Step 2: Connect USB

The ARMmite / ARMexpress Eval Kit comes with a USB cable. This cable allows
you to connect the ARMmite/ARMexpress directly to a computer equipped with
USB. Locate the USB jack on the side of the Eval PCB and plug one
end of the USB cable into it. When connected to a PC power is supplied by the PC, the optional power connection is not required, but both may be safely connected.

Locate the USB jack on your computer and plug the other end of
the cable into it.

Most PC's will sound a tone that indicates a new USB device has been connected.
It is Strongly recommended that you consult the PDF Installation Guides
from the Coridium installation CD or the proper Coridium\Win98_Drivers, Coridium\WinXPnt_Drivers, or Coridium\WinXPx64_Drivers directory.

In case you do not, here a few Essential Settings.




If asked to allow Windows Update to search for software answer No, Not this time.




Select Install from a specific location.




And browse to appropriate Coridium\Win***_Drivers directory or your Coridium installation CD.
From here it should be a simple matter of following the dialog instructions.

The Eval PCB or the ARMmite will be powered from the USB bus.  It may also be connected to a 7-12V DC power source simultaneously.

To verify connection with the USB and PC the LED on the Eval PCB should light up.


On to Step 3