I have been working with this Super Pro board for some time, now all I get are Zero readings from AD2, AD4, and AD5. I am using AD3 as a DAC output. I don't know if that is working at this moment. These were all working in the past. I haven't changed any setup code.
I did have a problem with a high voltage on the 3.3 Volt pin.
Did I damage the Super Pro board? The code runs except where the Zero readings cause operations to fail.
Questions on other types of hardware and getting it talking to the ARM CPU
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest