Super Pro A/D problem

Questions on other types of hardware and getting it talking to the ARM CPU
danlee58
Posts: 210
Joined: Thu Jan 17, 2013 2:29 am

Super Pro A/D problem

Postby danlee58 » Tue Aug 20, 2013 1:13 am

I have been working with this Super Pro board for some time, now all I get are Zero readings from AD2, AD4, and AD5. I am using AD3 as a DAC output. I don't know if that is working at this moment. These were all working in the past. I haven't changed any setup code.

I did have a problem with a high voltage on the 3.3 Volt pin.

Did I damage the Super Pro board? The code runs except where the Zero readings cause operations to fail.

Return to “Other Hardware interfaces”

Who is online

Users browsing this forum: No registered users and 1 guest